Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 105)

Rockwell Automation Publication 1752-UM001E-EN-P - June 2014 105
Configure Your Controller for DeviceNet Communication Chapter 7
3. From the appropriate pull-down menu, choose the Node Address, Slot in
the Virtual Backplane, and Baud rate.
The PanelView Plus interface is configured for DeviceNet node 7. The
SmartGuard controller has the DIP switches set for auto-sensing (left/
left/left/right from top to bottom). Choose the the baud rate that is
appropriate for your application.
4. Click the I/O Configuration tab.
The following dialog box appears.
5. Right-click Input and choose Add Address Block.
The following dialog box appears.
6. Enter 4 as the Length in Bytes.
This will match what the scanner is reading from the SmartGuard
controller.