Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 155)

Rockwell Automation Publication 1752-UM001E-EN-P - June 2014 155
Create Your Application Program Chapter 10
2. In the Function Block Editor, choose File>Change Password.
3. Type a password of up to six alphanumeric characters in the New Password
field.
4. Re-type the password in the Confirm Password field.
5. Click OK.
The user-defined function block cannot be edited or deleted without entering
the password.
We recommend using a password to protect user-defined function blocks that
have been tested to prevent unauthorized or unintentional changes once the
function block has been allocated in a user program.
Reuse User-defined Function Block Files
Project files (*.dnt) and user-defined function block files (*.fbd) exist as separate
files. You can reuse user-defined function block files when creating programs. You
must have Windows Administrator rights to import, save, delete, check, or edit
user-defined function blocks.
To reuse user-defined function blocks, follow these steps.
1. Create the user-defined function block as described on page 152.
2. Check the operation of the user-defined function block.
a. In the object list of the Logic Editor, right-click the new function block
and choose Edit.
b. Review the function block program and correct any problems.
c. Save the function block program, if you made any changes.
d. Close the Function Block Logic Editor.