Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 234)

234 Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
Appendix D Function Blocks Command Reference
ON-Delay Timer Function Block Timing Chart
User Mode Switch Function
Block Figure 59 - User Mode Switch Function Block Diagram
The User Mode Switch function block is used to monitor an operating mode
switch in the user system or device. The operating mode switch that can be
connected with this function block must be a 1-of-N type switch, that is, one of
the N contacts is ON. The function block supports a maximum of eight inputs
and eight corresponding outputs.
User Mode Switch Function Block Optional Outputs
The number of I/O can be increased on the In/Out Settings tab of the Function
Block Properties dialog box.
Set these parameters for the optional outputs.
Input
Idle to Run
Output
Enable
Set Value
Timer Value 0
Table 23 - User Mode Switch Optional Output Parameters
Parameter Range Default
Number of Inputs 2…8 2
Number of Outputs 2…8 2
1
2
3
4 5
6
7
8 1
2
3
4 5
6
7
8
!
Input 1 Output 1
Input 2 Output 2
Input 1 Output 1
Input 2 Output 2
Input 3 Output 3
Input 4 Output 4
Input 5 Output 5
Input 6
Output 7 Input 7
Output 8 Input 8
Fault Present
Output 6
Default Connections Maximum Inputs for User Mode Switch Function