Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 57)

Rockwell Automation Publication 1752-UM001E-EN-P - June 2014 57
Set Up Your EtherNet/IP Network Chapter 4
EtherNet/IP Network to a DeviceNet Network
Here is a connection between the EtherNet/IP network and the DeviceNet
network. The SmartGuard controller lets you use your personal computer that is
connected to the EtherNet/IP network to configure the 1791DS module on the
DeviceNet network by bridging through the SmartGuard controller.
Figure 15 - EtherNet/IP Network to a DeviceNet Network
IMPORTANT The bridging capability of the SmartGuard controller is limited. It is designed
for configuring safety DIO modules on another network, but it should not be
used to program other PLCs and must not be used as a bridging device during
machine operation.
SmartGuard as
EtherNet/IP bridge.
EtherNet/IP Network
PanelView™ Plus
CompactLogix
DeviceNet Network
Switch MicroLogix 1400
1791DS-IB8XOBV4