Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 59)

Rockwell Automation Publication 1752-UM001E-EN-P - June 2014 59
Set Up Your EtherNet/IP Network Chapter 4
USB Port to the EtherNet/IP Network
The SmartGuard controller supports bridging from the USB port to the
EtherNet/IP network. However, we recommend not using this feature but rather
connecting directly to the EtherNet/IP network to configure devices other than
the SmartGuard controller.
The SmartGuard controller can browse only on the Ethernet subnet that it is
connected to. You could browse to a MicroLogix 1400 controller or to a
CompactLogix controller, but you could not browse to a ControlLogix
controller because you cannot route past the 1756-ENBT module in the
ControlLogix chassis.
Figure 17 - USB Port to EtherNet/IP Network
SmartGuard as
EtherNet/IP bridge.
EtherNet/IP Network
PanelView Plus
CompactLogix
Switch
MicroLogix 1400