Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 153)

Rockwell Automation Publication 1752-UM001E-EN-P - June 2014 153
Create Your Application Program Chapter 10
Create User-defined Function Blocks
Follow these steps to create a user-defined function block.
1. Open the Logic Editor by right-clicking the controller, choosing
Properties, and clicking Edit on the Logic tab.
2. Choose FunctionBlock>Create.
3. On the IOProperty dialog box, define the number of inputs and outputs
for the function block.
4. Assign names to each input and output.
5. Click OK to open the Function Block Logic Editor.
6. Write the logic for the function block.
7. Choose File>Save and type a name for the function block, when
prompted.