Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 217)

Rockwell Automation Publication 1752-UM001E-EN-P - June 2014 217
Appendix
D
Function Blocks Command Reference
Introduction This appendix describes the function blocks used for programming.
Reset Function Block Figure 44 - Reset Function Block Diagram
The number of inputs can be increased from two to eight on the I/O Settings tab
of the Function Block Properties dialog box in RSNetWorx for DeviceNet
software. The default number of inputs is two.
Topic Page
Reset Function Block 217
Restart Function Block 219
Emergency Stop (ESTOP) 221
Light Curtain (LC) Function Block 223
Safety Gate Monitoring Function Block 225
Two-hand Control Function Block 230
OFF-delay Timer Function Block 232
ON-delay Timer Function Block 233
User Mode Switch Function Block 234
External Device Monitoring (EDM) 236
Muting 238
Enable Switch 254
Pulse Generator 257
Counter 258
Reset
Reset
Optional Input 1
Monitored Input
Output Enable
Monitored
Input
Output Enable
Static Release
Reset Required
Indication
Optional Input 2
Optional Input 3
Optional Input 4
Optional Input 5
Optional Input 6
Static Release
Reset Required
Indication
Default Connections Maximum Inputs for Reset Function