Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 42)

42 Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
Chapter 3 Set Up Your DeviceNet Network
3. From the pull-down the list of Available Driver Types, add the driver for
your network.
4. Configure the driver.
The settings you make are dependent upon the network you choose and
whether you are using a communication card or interface module.
Make Sure the Driver Works
1. Check the Configure Drivers dialog box to make sure that the driver is
running.
2. Close the dialog box.
3. Open the RSWho dialog box.
4. Double-click the driver to see the network.
Commission All Nodes If you have not specifically set the node address and communication rate of your
devices by using hardware switches, you will need to commission each device by
using RSNetWorx for DeviceNet software.
Before you can use RSNetWorx for DeviceNet’s Node Commissioning tool, your
computer and your DeviceNet devices must be connected to the DeviceNet
network.
Use the Node Commissioning tool in RSNetWorx for DeviceNet software to set
the node address and/or communication rate of the SmartGuard controller and
other DeviceNet devices.
Follow the guidelines on page 26 when selecting node addresses for your
DeviceNet network.
Network Driver
RS-232 RS-232 DF1 devices
EtherNet/IP Ethernet devices
DeviceNet DeviceNet drivers
USB SmartGuard USB Driver
IMPORTANT To allow the node address to be set by using the Node Commissioning tool in
RSNetWorx for DeviceNet software, set the node address rotary switch on the
controller to a value from 64…99.
See page 26 for information on setting the node address by using the rotary
switch.