Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 130)

130 Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
Chapter 8 Configure Your Controller for EtherNet/IP Communication
Set Up Your Controller as a
Slave by Using RSLogix 5000
Software Generic Profile Once you have configured the data to be shared in the SmartGuard controller,
you can now use the RSLogix 5000 software and the standard generic profile to
exchange that data with a Logix controller.
Follow these steps to connect to the controller.
1. Right-click the Ethernet network in the controller organizer and choose
New Module.
2. Expand the Communications group and select ETHERNET-MODULE.
3. Click OK.
4. On the New Module dialog box, set the parameters as needed.