Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 161)

Rockwell Automation Publication 1752-UM001E-EN-P - June 2014 161
Download and Verify Chapter 11
Verifying Your DeviceNet
Safety Configuration
The Safety Device Verification Wizard, accessed from RSNetWorx for
DeviceNet software, guides you through the process of verifying the
configuration of your safety devices and provides the means for safety-locking
those devices. The verification process includes upload and comparison of the
configuration stored in the device and the configuration stored in the
RSNetWorx for DeviceNet software configuration file. The configuration is
displayed in a report to facilitate visual verification and record keeping.
Start the Safety Device
Verification Wizard Follow these steps to run the Safety Device Verification Wizard.
1. Choose Network>Safety Device Verification Wizard.
The Welcome dialog box, which describes the verification process, appears.
2. Click Next.
Determine if Devices Can Be
Verified When the Safety Device Verification Wizard browses the network, it checks the
safety status of the devices on the network to determine if the devices can be
verified.
If any devices are in a state that prevents the wizard from continuing the
verification process, the Unable to verify the listed devices dialog box appears
IMPORTANT Before running the Safety Device Verification Wizard, you should browse
and upload your network and test the safety devices and all of their safety
functions on your network to verify that they are operating properly. You
must fully test your application prior to safety-locking your devices.
Refer to the SmartGuard Controller Safety Reference Manual, publication
1752-RM001, for information on verification testing for safety applications.
IMPORTANT Some devices on your network may not support verification by the Safety
Device Verification Wizard. Consult the user documentation to determine the
method required for verifying these devices.