Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 128)

128 Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
Chapter 8 Configure Your Controller for EtherNet/IP Communication
d. Select the byte you would like to add.
e. Click OK.
f. Repeat steps a...e to add additional Routing I/O.
8. Under I/O Tag, click New to create an I/O tag.
Multiple I/O tags can be defined in an I/O assembly. I/O tags up to 16
bytes can be defined in each I/O assembly. The I/O tags here can be used
in the Logic Editor. For example, you can create tags that represent faults
from instructions in your function block code, and then display these on
an HMI device.
The following dialog box appears.
9. Enter a name for the tag and check the type.
The choices are BOOL, BYTE, WORD, or DWORD.