Microsens MS453490M Management Guide - Manual (Page 136)

C HAPTER 5 | Interface Configuration
Trunk Configuration
– 136 –
To add member ports to a static trunk:
1.
Click Interface, Trunk, Static.
2.
Select Configure Trunk from the Step list.
3.
Select Add Member from the Action list.
4.
Select a trunk identifier.
5.
Set the unit and port for an additional trunk member.
6.
Click Apply.
Figure 39: Adding Static Trunks Members
To configure connection parameters for a static trunk:
1.
Click Interface, Trunk, Static.
2.
Select Configure General from the Step list.
3.
Select Configure from the Action list.
4.
Modify the required interface settings. (Refer to "Configuring by Port
List" on page 117 for a description of the parameters.)
5. Click Apply.
Figure 40: Configuring Connection Parameters for a Static Trunk