Microsens MS453490M Management Guide - Manual (Page 505)

C HAPTER 21 | System Management Commands
System Status
– 505 –
E XAMPLE
Console#show process cpu
CPU Utilization in the past 5 seconds : 3.98%
Console#
show running-
config
This command displays the configuration information currently in use.
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
◆ Use this command in conjunction with the show startup-config
command to compare the information in running memory to the
information stored in non-volatile memory.
◆ This command displays settings for key command modes. Each mode
group is separated by “!” symbols, and includes the configuration mode
command, and corresponding commands. This command displays the
following information:
■
MAC address for the switch
■
SNTP server settings
■
SNMP community strings
■
Users (names, access levels, and encrypted passwords)
■
VLAN database (VLAN ID, name and state)
■
VLAN configuration settings for each interface
■
Multiple spanning tree instances (name and interfaces)
■
IP address configured for management VLAN
■
Layer 4 precedence settings
■
Spanning tree settings
■
Interface settings
■
Any configured settings for the console port and Telnet
E XAMPLE
Console#show running-config
Building startup configuration. Please wait...
!<stackingDB>00</stackingDB>
!<stackingMac>01_00-e0-0c-00-00-fd_00</stackingMac>
!
snmp-server community public ro
snmp-server community private rw
!
snmp-server enable traps authentication
!
username admin access-level 15
username admin password 7 21232f297a57a5a743894a0e4a801fc3
username guest access-level 0
username guest password 7 084e0343a0486ff05530df6c705c8bb4
enable password level 15 7 1b3231655cebb7a1f783eddf27d254ca
!
vlan database
VLAN 1 name DefaultVlan media ethernet state active
VLAN 4093 media ethernet state active
!