Microsens MS453490M Management Guide - Manual (Page 894)

C HAPTER 38 | LLDP Commands
– 894 –
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv mac-phy
Console(config-if)#
lldp dot3-tlv max-
frame
This command configures an LLDP-enabled port to advertise its maximum
frame size. Use the no form to disable this feature.
S YNTAX
[no] lldp dot3-tlv max-frame
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
Refer to "Frame Size" on page 509 for information on configuring the
maximum frame size for this switch.
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dot3-tlv max-frame
Console(config-if)#
lldp notification This command enables the transmission of SNMP trap notifications about
LLDP changes. Use the no form to disable LLDP notifications.
S YNTAX
[no] lldp notification
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
◆ This option sends out SNMP trap notifications to designated target
stations at the interval specified by the lldp notification-interval
command. Trap notifications include information about state changes in
the LLDP MIB (IEEE 802.1AB), or organization-specific LLDP-EXT-DOT1
and LLDP-EXT-DOT3 MIBs.