Microsens MS453490M Management Guide - Manual (Page 709)

C HAPTER 27 | Interface Commands
– 709 –
show interfaces
counters
This command displays interface statistics.
S YNTAX
show interfaces counters [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
D EFAULT S ETTING
Shows the counters for all interfaces.
C OMMAND M ODE
Normal Exec, Privileged Exec
C OMMAND U SAGE
If no interface is specified, information on all interfaces is displayed. For a
description of the items displayed by this command, see "Showing Port or
Trunk Statistics" on page 128 .
E XAMPLE
Console#show interfaces counters ethernet 1/1
Ethernet 1/ 1
===== IF table Stats =====
2166458 Octets Input
14734059 Octets Output
14707 Unicast Input
19806 Unicast Output
0 Discard Input
0 Discard Output
0 Error Input
0 Error Output
0 Unknown Protos Input
0 QLen Output
===== Extended Iftable Stats =====
23 Multi-cast Input
5525 Multi-cast Output
170 Broadcast Input
11 Broadcast Output
===== Ether-like Stats =====
0 Alignment Errors
0 FCS Errors
0 Single Collision Frames
0 Multiple Collision Frames
0 SQE Test Errors
0 Deferred Transmissions
0 Late Collisions
0 Excessive Collisions
0 Internal Mac Transmit Errors
0 Internal Mac Receive Errors
0 Frames Too Long
0 Carrier Sense Errors
0 Symbol Errors