Microsens MS453490M Management Guide - Manual (Page 188)

C HAPTER 7 | Address Table Settings
Changing the Aging Time
– 188 –
4. Click Apply.
Figure 83: Configuring Static MAC Addresses
To show the static addresses in MAC address table:
1. Click MAC Address, Static.
2. Select Show from the Action list.
Figure 84: Displaying Static MAC Addresses
C HANGING THE A GING T IME
Use the MAC Address > Dynamic (Configure Aging) page to set the aging
time for entries in the dynamic address table. The aging time is used to
age out dynamically learned forwarding information.
CLI R EFERENCES
◆ "mac-address-table aging-time" on page 753
P ARAMETERS
These parameters are displayed:
◆ Aging Status – Enables/disables the function.
◆ Aging Time – The time after which a learned entry is discarded.
(Range: 10-844 seconds; Default: 300 seconds)