Attaching a policy map to a port, Figure 127: showing the rules for a policy map, Binding to a port – Microsens MS453490M Management Guide User Manual
Page 249
C
HAPTER
12
| Quality of Service
Attaching a Policy Map to a Port
– 249 –
To show the rules for a policy map:
1.
Click Traffic, DiffServ.
2.
Select Configure Policy from the Step list.
3.
Select Show Rule from the Action list.
Figure 127: Showing the Rules for a Policy Map
A
TTACHING
A
P
OLICY
M
AP
TO
A
P
ORT
Use the Traffic > DiffServ (Configure Interface) page to bind a policy map
to an ingress port.
CLI R
EFERENCES
◆
"Quality of Service Commands" on page 831
C
OMMAND
U
SAGE
◆
First define a class map, define a policy map, and bind the service
policy to the required interface.
◆
Only one policy map can be bound to an interface.
◆
The switch does not allow a policy map to be bound to an interface for
egress traffic.
P
ARAMETERS
These parameters are displayed:
◆
Port – Specifies a port.
◆
Ingress – Applies the selected rule to ingress traffic.