Figure 45: configuring lacp parameters on a port, Figure 46: showing members of a dynamic trunk – Microsens MS453490M Management Guide User Manual
Page 141
Advertising
C
HAPTER
5
| Interface Configuration
Trunk Configuration
– 141 –
To configure LACP parameters for group members:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Aggregation Port from the Step list.
3.
Select Configure from the Action list.
4.
Click Actor or Partner.
5.
Configure the required settings.
6.
Click Apply.
Figure 45: Configuring LACP Parameters on a Port
To show the active members of a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step List.
3.
Select Show Member from the Action List.
4.
Select a Trunk.
Figure 46: Showing Members of a Dynamic Trunk
Advertising