Microsens MS453490M Management Guide - Manual (Page 871)

C HAPTER 37 | Multicast Filtering Commands
IGMP Filtering and Throttling
– 871 –
E XAMPLE
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#permit
Console(config-igmp-profile)#
range This command specifies multicast group addresses for a profile. Use the no
form to delete addresses from a profile.
S YNTAX
[no] range low-ip-address [high-ip-address]
low-ip-address - A valid IP address of a multicast group or start of a
group range.
high-ip-address - A valid IP address for the end of a multicast group
range.
D EFAULT S ETTING
None
C OMMAND M ODE
IGMP Profile Configuration
C OMMAND U SAGE
Enter this command multiple times to specify more than one multicast
address or address range for a profile.
E XAMPLE
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#range 239.1.1.1
Console(config-igmp-profile)#range 239.2.3.1 239.2.3.100
Console(config-igmp-profile)#
ip igmp filter
(Interface
Configuration)
This command assigns an IGMP filtering profile to an interface on the
switch. Use the no form to remove a profile from an interface.
S YNTAX
[no] ip igmp filter profile-number
profile-number - An IGMP filter profile number.
(Range: 1-4294967295)
D EFAULT S ETTING
None
C OMMAND M ODE
Interface Configuration