Configuring a list of name servers, Configuring a list of name – Microsens MS453490M Management Guide User Manual
Page 436
C
HAPTER
17
| IP Services
Configuring a List of Name Servers
– 436 –
C
ONFIGURING
A
L
IST
OF
N
AME
S
ERVERS
Use the IP Service > DNS - General (Add Name Server) page to configure a
list of name servers to be tried in sequential order.
CLI R
EFERENCES
◆
◆
C
OMMAND
U
SAGE
◆
To enable DNS service on this switch, configure one or more name
servers, and enable domain lookup status (see
DNS Service Parameters" on page 433
◆
When more than one name server is specified, the servers are queried
in the specified sequence until a response is received, or the end of the
list is reached with no response.
◆
If all name servers are deleted, DNS will automatically be disabled. This
is done by disabling the domain lookup status.
P
ARAMETERS
These parameters are displayed:
Name Server IP Address – Specifies the address of a domain name
server to use for name-to-address resolution. Up to six IP addresses can be
added to the name server list.
W
EB
I
NTERFACE
To create a list name servers:
1.
Click IP Service, DNS.
2.
Select Add Name Server from the Action list.
3.
Enter one name server at a time.
4.
Click Apply.
Figure 263: Configuring a List of Name Servers for DNS