Microsens MS453490M Management Guide - Manual (Page 892)

C HAPTER 38 | LLDP Commands
– 892 –
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv proto-vid
Console(config-if)#
lldp dot1-tlv pvid This command configures an LLDP-enabled port to advertise its default
VLAN ID. Use the no form to disable this feature.
S YNTAX
[no] lldp dot1-tlv pvid
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
The port’s default VLAN identifier (PVID) indicates the VLAN with which
untagged or priority-tagged frames are associated (see the switchport
native vlan command).
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv pvid
Console(config-if)#
lldp dot1-tlv vlan-
name
This command configures an LLDP-enabled port to advertise its VLAN
name. Use the no form to disable this feature.
S YNTAX
[no] lldp dot1-tlv vlan-name
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
This option advertises the name of all VLANs to which this interface has
been assigned. See "switchport allowed vlan" on page 790 and "protocol-
vlan protocol-group (Configuring Interfaces)" on page 803 .