Microsens MS453490M Management Guide - Manual (Page 551)

C HAPTER 21 | System Management Commands
Switch Clustering
– 551 –
cluster member This command configures a Candidate switch as a cluster Member. Use the
no form to remove a Member switch from the cluster.
S YNTAX
cluster member mac-address mac-address id member-id
no cluster member id member-id
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch.
(Range: 1-36)
D EFAULT S ETTING
No Members
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ The maximum number of cluster Members is 36.
◆ The maximum number of cluster Candidates is 100.
E XAMPLE
Console(config)#cluster member mac-address 00-11-22-33-44-57 id 5
Console(config)#
rcommand This command provides access to a cluster Member CLI for configuration.
S YNTAX
rcommand id member-id
member-id - The ID number of the Member switch.
(Range: 1-36)
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
◆ This command only operates through a Telnet connection to the
Commander switch. Managing cluster Members using the local console
CLI on the Commander is not supported.
◆ There is no need to enter the username and password for access to the
Member switch CLI.