Microsens MS453490M Management Guide - Manual (Page 353)

C HAPTER 15 | Basic Administration Protocols
Configuring Event Logging
– 353 –
Figure 201: Configuring Settings for System Memory Logs
To show the error messages logged to system memory:
1.
Click Administration, Log, System.
2.
Select Show System Logs from the Step list.
This page allows you to scroll through the logged system and event
messages. The switch can store up to 2048 log entries in temporary
random access memory (RAM; i.e., memory flushed on power reset)
and up to 4096 entries in permanent flash memory.
Figure 202: Showing Error Messages Looged to System Memory
R EMOTE L OG
C ONFIGURATION
Use the Administration > Log > Remote page to send log messages to
syslog servers or other management stations. You can also limit the event
messages sent to only those messages below a specified level.
CLI R EFERENCES
◆ "Event Logging" on page 529
P ARAMETERS
These parameters are displayed:
◆ Remote Log Status – Enables/disables the logging of debug or error
messages to the remote logging process. (Default: Disabled)