Microsens MS453490M Management Guide - Manual (Page 322)

C HAPTER 14 | Security Measures
Filtering IP Addresses for Management Access
– 322 –
◆ When entering addresses for the same group (i.e., SNMP, web or
Telnet), the switch will not accept overlapping address ranges. When
entering addresses for different groups, the switch will accept
overlapping address ranges.
◆ You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.
◆ You can delete an address range just by specifying the start address, or
by specifying both the start address and end address.
P ARAMETERS
These parameters are displayed:
◆ Mode
■
Web – Configures IP address(es) for the web group.
■
SNMP – Configures IP address(es) for the SNMP group.
■
Telnet – Configures IP address(es) for the Telnet group.
◆ Start IP Address – A single IP address, or the starting address of a
range.
◆ End IP Address – The end address of a range.
W EB I NTERFACE
To create a list of IP addresses authorized for management access:
1. Click Security, IP Filter.
2.
Select Add from the Action list.
3. Select the management interface to filter (Web, SNMP, Telnet).
4. Enter the IP addresses or range of addresses that are allowed
management access to an interface.
5. Click Apply
Figure 184: Creating an IP Address Filter for Management Access