Microsens MS453490M Management Guide - Manual (Page 793)

C HAPTER 34 | VLAN Commands
Configuring VLAN Interfaces
– 793 –
switchport native
vlan
This command configures the PVID (i.e., default VLAN ID) for a port. Use
the no form to restore the default.
S YNTAX
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4093, no leading
zeroes)
D EFAULT S ETTING
VLAN 1
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
◆ When using Access mode, and an interface is assigned to a new VLAN,
its PVID is automatically set to the identifier for that VLAN. When using
Hybrid mode, the PVID for an interface can be set to any VLAN for
which it is an untagged member.
◆ If acceptable frame types is set to all or switchport mode is set to
hybrid, the PVID will be inserted into all untagged frames entering the
ingress port.
E XAMPLE
The following example shows how to set the PVID for port 1 to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
vlan-trunking This command allows unknown VLAN groups to pass through the specified
interface. Use the no form to disable this feature.
S YNTAX
[no] vlan-trunking
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)