Disconnect 528, Disconnect – Microsens MS453490M Management Guide User Manual
Page 528
C
HAPTER
21
| System Management Commands
Line
– 528 –
C
OMMAND
M
ODE
Line Configuration
C
OMMAND
U
SAGE
◆
If a login attempt is not detected within the timeout interval, the
connection is terminated for the session.
◆
This command applies to both the local console and Telnet connections.
◆
The timeout for Telnet cannot be disabled.
◆
Using the command without specifying a timeout restores the default
setting.
E
XAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#
disconnect
This command terminates an SSH, Telnet, or console connection.
S
YNTAX
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
C
OMMAND
M
ODE
Privileged Exec
C
OMMAND
U
SAGE
Specifying session identifier “0” will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an SSH
or Telnet connection.
E
XAMPLE
Console#disconnect 1
Console#
R
ELATED
C
OMMANDS