Microsens MS453490M Management Guide User Manual
Page 142
Advertising
C
HAPTER
5
| Interface Configuration
Trunk Configuration
– 142 –
To configure connection parameters for a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step List.
3.
Select Configure from the Action List.
4.
Modify the required interface settings. (See
for a description of the interface settings.)
5.
Click Apply.
Figure 47: Configuring Connection Settings for Dynamic Trunks
To display connection parameters for a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step List.
3.
Select Show from the Action List.
Figure 48: Displaying Connection Parameters for Dynamic Trunks
Advertising