Mapping protocol groups to interfaces – Microsens MS453490M Management Guide User Manual
Page 177
C
HAPTER
6
| VLAN Configuration
Protocol VLANs
– 177 –
M
APPING
P
ROTOCOL
G
ROUPS
TO
I
NTERFACES
Use the VLAN > Protocol (Configure Interface - Add) page to map a
protocol group to a VLAN for each interface that will participate in the
group.
CLI R
EFERENCES
◆
"protocol-vlan protocol-group (Configuring Interfaces)" on page 803
C
OMMAND
U
SAGE
◆
When creating a protocol-based VLAN, only assign interfaces using this
configuration screen. If you assign interfaces using any of the other
VLAN menus such as the VLAN Static table (
), these interfaces
will admit traffic of any protocol type into the associated VLAN.
◆
When a frame enters a port that has been assigned to a protocol VLAN,
it is processed in the following manner:
■
If the frame is tagged, it will be processed according to the standard
rules applied to tagged frames.
■
If the frame is untagged and the protocol type matches, the frame
is forwarded to the appropriate VLAN.
■
If the frame is untagged but the protocol type does not match, the
frame is forwarded to the default VLAN for this interface.
P
ARAMETERS
These parameters are displayed:
◆
Interface – Displays a list of ports or trunks.
◆
Port – Port Identifier. (Range: 1-10)
◆
Trunk – Trunk Identifier. (Range: 1-5)
◆
Protocol Group ID – Protocol Group ID assigned to the Protocol VLAN
Group. (Range: 1-2147483647)
◆
VLAN ID – VLAN to which matching protocol traffic is forwarded.
(Range: 1-4093)