Microsens MS453490M Management Guide - Manual (Page 782)

C HAPTER 34 | VLAN Commands
GVRP and Bridge Extension Commands
– 782 –
GVRP AND B RIDGE E XTENSION C OMMANDS
GARP VLAN Registration Protocol defines a way for switches to exchange
VLAN information in order to automatically register VLAN members on
interfaces across the network. This section describes how to enable GVRP
for individual interfaces and globally for the switch, as well as how to
display default configuration settings for the Bridge Extension MIB.
bridge-ext gvrp This command enables GVRP globally for the switch. Use the no form to
disable it.
S YNTAX
[no] bridge-ext gvrp
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
GVRP defines a way for switches to exchange VLAN information in order to
register VLAN members on ports across the network. This function should
be enabled to permit automatic VLAN registration, and to support VLANs
which extend beyond the local switch.
E XAMPLE
Console(config)#bridge-ext gvrp
Console(config)#
Table 104: GVRP and Bridge Extension Commands
Command Function Mode
bridge-ext gvrp Enables GVRP globally for the switch GC
garp timer Sets the GARP timer for the selected function IC
switchport forbidden vlan Configures forbidden VLANs for an interface IC
switchport gvrp Enables GVRP for an interface IC
show bridge-ext Shows the global bridge extension configuration PE
show garp timer Shows the GARP timer for the selected function NE, PE
show gvrp configuration Displays GVRP configuration for the selected interface NE, PE