Microsens MS453490M Management Guide - Manual (Page 747)

C HAPTER 31 | Automatic Traffic Control Commands
– 747 –
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
This command can be used to manually stop a control response any time
after the specified action has been triggered.
E XAMPLE
Console#auto-traffic-control broadcast control-release interface ethernet 1/1
Console#
auto-traffic-control
auto-control-release
This command automatically releases a control response after the time
specified in the auto-traffic-control release-timer command has expired.
S YNTAX
auto-traffic-control {broadcast | multicast}
auto-control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
C OMMAND M ODE
Interface Configuration (Ethernet)
C OMMAND U SAGE
This command can be used to automatically stop a control response after
the specified action has been triggered and the release timer has expired.
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast auto-control-release
Console(config-if)#
snmp-server enable
port-traps atc
broadcast-alarm-
clear
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no
form to disable this trap.
S YNTAX
[no] snmp-server enable port-traps atc broadcast-alarm-clear
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)