Microsens MS453490M Management Guide - Manual (Page 864)

C HAPTER 37 | Multicast Filtering Commands
IGMP Snooping
– 864 –
ip igmp snooping
vlan proxy-query-
resp-intvl
This command configures the maximum time the system waits for a
response to proxy general queries. Use the no form to restore the default.
S YNTAX
ip igmp snooping vlan vlan-id proxy-query-resp-intvl interval
no ip igmp snooping vlan vlan-id proxy-query-resp-intvl
vlan-id - VLAN ID (Range: 1-4093)
interval - The maximum time the system waits for a response to
proxy general queries. (Range: 10-31744 tenths of a second)
D EFAULT S ETTING
100 (10 seconds)
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
This command will take effect only if IGMP snooping proxy reporting is
enabled ( page 851 ).
E XAMPLE
Console(config)#ip igmp snooping vlan 1 proxy-query-resp-intvl 20
Console(config)#
ip igmp snooping
vlan static
This command adds a port to a multicast group. Use the no form to
remove the port.
S YNTAX
[no] ip igmp snooping vlan vlan-id static ip-address interface
vlan-id - VLAN ID (Range: 1-4093)
ip-address - IP address for multicast group
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration