Microsens MS453490M Management Guide - Manual (Page 827)

C HAPTER 35 | Class of Service Commands
Priority Commands (Layer 3 and 4)
– 827 –
show qos map
dscp-mutation
This command shows the ingress DSCP to internal DSCP map.
S YNTAX
show qos map dscp-mutation interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
This map is only used when the QoS mapping mode is set to “DSCP” by the
qos map trust-mode command, and the ingress packet type is IPv4.
E XAMPLE
The ingress DSCP is composed of “d1” (most significant digit in the left
column) and “d2” (least significant digit in the top row (in other words,
ingress DSCP = d1 * 10 + d2); and the corresponding Internal DSCP and
drop precedence is shown at the intersecting cell in the table.
Console#show qos map dscp-mutation interface ethernet 1/5
dscp mutation map.(x,y),x: phb,y: drop precedence:
d1: d2 0 1 2 3 4 5 6 7 8 9
-----------------------------------------------------------------
0 : (0,0) (0,1) (0,0) (0,3) (0,0) (0,1) (0,0) (0,3) (1,0) (1,1)
1 : (1,0) (1,3) (1,0) (1,1) (1,0) (1,3) (2,0) (2,1) (2,0) (2,3)
2 : (2,0) (2,1) (2,0) (2,3) (3,0) (3,1) (3,0) (3,3) (3,0) (3,1)
3 : (3,0) (3,3) (4,0) (4,1) (4,0) (4,3) (4,0) (4,1) (4,0) (4,3)
4 : (5,0) (5,1) (5,0) (5,3) (5,0) (5,1) (6,0) (5,3) (6,0) (6,1)
5 : (6,0) (6,3) (6,0) (6,1) (6,0) (6,3) (7,0) (7,1) (7,0) (7,3)
6 : (7,0) (7,1) (7,0) (7,3)
Console#
show qos map phb-
queue
This command shows internal per-hop behavior to hardware queue map.
S YNTAX
show qos map phb-queue interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)