Microsens MS453490M Management Guide - Manual (Page 518)

C HAPTER 21 | System Management Commands
File Management
– 518 –
◆ Any changes made to the default setting can be displayed with the
show running-config ( page 505 ) or show startup-config ( page 506 )
commands.
E XAMPLE
Console(config)#upgrade opcode auto
Console(config)#upgrade opcode path tftp://192.168.0.1/sm24/
Console(config)#
If a new image is found at the specified location, the following type of
messages will be displayed during bootup.
.
.
.
Automatic Upgrade is looking for a new image
New image detected: current version 1.1.1.0; new version 1.1.1.2
Image upgrade in progress
The switch will restart after upgrade succeeds
Downloading new image
Flash programming started
Flash programming completed
The switch will now restart
.
.
.
upgrade opcode
path
This command specifies an TFTP server and directory in which the new
opcode is stored. Use the no form of this command to clear the current
setting.
S YNTAX
upgrade opcode path opcode-dir-url
no upgrade opcode path
opcode-dir-url - The location of the new code.
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ This command is used in conjunction with the upgrade opcode auto
command to facilitate automatic upgrade of new operational code
stored at the location indicated by this command.
◆ The name for the new image stored on the TFTP server must be
ms453490m.bix. However, note that file name is not to be included in
this command.