Microsens MS453490M Management Guide - Manual (Page 329)

C HAPTER 14 | Security Measures
Configuring 802.1X Port Authentication
– 329 –
P ARAMETERS
These parameters are displayed:
◆ Port – Port number.
◆ Status – Indicates if authentication is enabled or disabled on the port.
The status is disabled if the control mode is set to Force-Authorized.
◆ Authorized – Displays the 802.1X authorization status of connected
clients.
■
Yes – Connected client is authorized.
■
No – Connected client is not authorized.
◆ Supplicant – Indicates the MAC address of a connected client.
◆ Control Mode – Sets the authentication mode to one of the following
options:
■
Auto – Requires a dot1x-aware client to be authorized by the
authentication server. Clients that are not dot1x-aware will be
denied access.
■
Force-Authorized – Forces the port to grant access to all clients,
either dot1x-aware or otherwise. (This is the default setting.)
■
Force-Unauthorized – Forces the port to deny access to all
clients, either dot1x-aware or otherwise.
◆ Operation Mode – Allows single or multiple hosts (clients) to connect
to an 802.1X-authorized port. (Default: Single-Host)
■
Single-Host – Allows only a single host to connect to this port.
■
Multi-Host – Allows multiple host to connect to this port.
In this mode, only one host connected to a port needs to pass
authentication for all other hosts to be granted network access.
Similarly, a port can become unauthorized for all hosts if one
attached host fails re-authentication or sends an EAPOL logoff
message.
■
MAC-Based – Allows multiple hosts to connect to this port, with
each host needing to be authenticated.
In this mode, each host connected to a port needs to pass
authentication. The number of hosts allowed access to a port
operating in this mode is limited only by the available space in the
secure address table (i.e., up to 1024 addresses).
◆ Max MAC Count – The maximum number of hosts that can connect to
a port when the Multi-Host operation mode is selected.
(Range: 1-1024; Default: 5)