GE Industrial Solutions AF-650 GP General Purpose Drive Programming Guide - Manual (Page 30)

The relation will depend on the type of unit selected in
K-30 Unit for Custom Readout:
Unit Type Speed Relation
Dimensionless
Linear
Speed
Flow, volume
Flow, mass
Velocity
Length
Temperature
Pressure Quadratic
Power Cubic
Table 3.5
K-30 Unit for Custom Readout
Option: Function:
It is possible to program a value to be shown in
the display of the keypad. The value will have a
linear, squared or cubed relation to speed. This
relation will depend on the unit selected (see
Table 3.5). The actual calculated value can be read
in DR-09 Custom Readout, and/or shown in the
display be selecting [DR-09] Custom Readout in
K-20 Display Line 1.1 Small to K-24 Display Line 3
Large.
[0] * None
[1] %
[5] PPM
[10] 1/min
[11] rpm
[12] Pulse/s
[20] l/s
[21] l/min
[22] l/h
[23] m3/s
[24] m3/min
[25] m3/h
[30] kg/s
[31] kg/min
[32] kg/h
[33] t/min
[34] t/h
[40] m/s
[41] m/min
[45] m
[60] °C
[70] mbar
[71] bar
[72] Pa
[73] kPa
[74] m WG
[80] kW
[120] GPM
K-30 Unit for Custom Readout
Option: Function:
[121] gal/s
[122] gal/min
[123] gal/h
[124] CFM
[125] ft3/s
[126] ft3/min
[127] ft3/h
[130] lb/s
[131] lb/min
[132] lb/h
[140] ft/s
[141] ft/min
[145] ft
[160] °F
[170] psi
[171] lb/in2
[172] in WG
[173] ft WG
[180] HP
K-31 Min Value of Custom Readout
Range: Function:
0 CustomRea-
doutUnit *
[-999999.99 -
par. K-32
CustomRea-
doutUnit]
This parameter sets the min.
value of the custom defined
readout (occurs at zero
speed). Only possible to set
different from 0 is when
selecting a linear unit in
K-30 Unit for Custom
Readout. For Quadratic and
Cubic units the minimum
value will be 0.
K-32 Max Value of Custom Readout
Range: Function:
100 CustomRea-
doutUnit *
[par. K-31 -
999999.99
CustomRea-
doutUnit]
This parameter sets the
max value to be shown
when the speed of the
motor has reached the set
value for F-17 Motor Speed
High Limit [RPM] or
F-15 Motor Speed High Limit
[Hz] (depends on setting in
K-02 Motor Speed Unit).
K-37 Display Text 1
Range: Function:
0 * [0 - 0] Enter a text which can be viewed in the graphical
display by selecting [37] Display Text 1 in
K-20 Display Line 1.1 Small, K-21 Display Line 1.2
Small, K-22 Display Line 1.3 Small, K-23 Display Line 2
Large or K-24 Display Line 3 Large.
Parameter Descriptions AF-650 GP Programming Guide
DET-618C 29
3 3