Dell POWEREDGE M1000E - Manual (Page 1013)

Loopback Interface Commands 1013
51
Loopback Interface Commands
PowerConnect provides for the creation, deletion, and management of
loopback interfaces. They are dynamic interfaces that are created and deleted
by user configuration.
A loopback interface is always expected to be up. As such, it provides a means
to configure a stable IP address on the device which may be referred to by
other switches in the network. This interface never transmits data but may
receive data. It is typically expected to be used by routing protocols.
Support for the internal loopback address, if present, is limited to testing the
IP stack.
Commands in this Chapter
This chapter explains the following commands:
interface loopback
Use the interface loopback command in Global Configuration mode to enter
the Interface Loopback configuration mode.
Syntax
interface loopback loopback-id
no interface loopback loopback-id
• loopback-id — Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
interface loopback show interfaces loopback
2CSPC4.XModular-SWUM200.book Page 1013 Thursday, March 10, 2011 11:18 AM