Dell POWEREDGE M1000E - Manual (Page 980)

980 IPv6 Routing Commands
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example suppresses router advertisement transmission.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd suppress-ra
ipv6 route
Use the ipv6 route command in Global Configuration mode to configure an
IPv6 static route. Use the no form of the command to remove a preference,
an individual next hop, or all next hops for a route. Using the no ipv6 route
distance form causes the system to use the system default administrative
distance.
Syntax
ipv6 route distance
ipv6 route ipv6-prefix/prefix-length {ipv6-address | interface-type ipv6-
address} [ preference ]
no ipv6 route ipv6-prefix/prefix-length ipv6-address preference
no ipv6 route ipv6-prefix/prefix-length interface-type ipv6-address
no ipv6 route ipv6-prefix/prefix-length interface
Syntax Description
Parameter Description
distance The default administrative distance for static routes. (Range 1-
255)
ipv6-prefix An IPv6 prefix representing the subnet that can be reached via
the next-hop neighbor.
2CSPC4.XModular-SWUM200.book Page 980 Thursday, March 10, 2011 11:18 AM