Dell POWEREDGE M1000E - Manual (Page 565)

Port Aggregator Commands 565
29
Port Aggregator Commands
This chapter explains the following commands:
add ethernet
Use the add ethernet command to add member Ethernet ports to the
Aggregator Group. To remove member Ethernet ports from the Aggregator
Group/Zone, use the no form of this command.
Syntax
add ethernet intf-list
no add ethernet intf-list
• intf-list — List of Ethernet interfaces. Separate nonconsecutive ports with
a comma and no spaces. Use a hyphen to designate a range of ports.
(Range: valid Ethernet interface list or range)
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
add ethernet negotiation
duplex port-aggregator group
minimum active uplinks show bridge address-table
mtu disable speed
2CSPC4.XModular-SWUM200.book Page 565 Thursday, March 10, 2011 11:18 AM