Dell POWEREDGE M1000E - Manual (Page 401)

Ethernet Configuration Commands 401
When you use the no storm-control multicast command to "disable" storm-
control after having set the level or rate to a non-default value, that value is
still set but is not active until you re-enable storm-control.
Syntax
storm-control multicast [level | rate ]
no storm-control multicast
• level— The configured rate as a percentage of link-speed.
•
rate — The configured rate in kilobits per second (kbps). (Range: 0-100)
Default Configuration
The default value is 5.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-1/0/1)#storm-control multicast
level 5
storm-control unicast
Use the storm-control unicast command in Interface Configuration mode to
enable unknown unicast storm control for an interface. If the mode is
enabled, unicast storm recovery is active, and if the rate of unknown L2
unicast (destination lookup failure) traffic ingressing on an interface increases
beyond the configured threshold, the traffic will be dropped. Therefore, the
rate of unknown unicast traffic will be limited to the configured threshold.
When you use the no storm-control multicast command to "disable" storm-
control after having set the level or rate to a non-default value, that value is
still set but is not active until you re-enable storm-control.
2CSPC4.XModular-SWUM200.book Page 401 Thursday, March 10, 2011 11:18 AM