Dell POWEREDGE M1000E - Manual (Page 742)

742 VLAN Commands
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering
disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to enables port ingress filtering on 1/0/8.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#switchport general ingress-
filtering disable
switchport general pvid
Use the switchport general pvid command in Interface Configuration mode
to configure the Port VLAN ID (PVID) when the interface is in general mode.
Use the switchport mode general command to set the VLAN membership
mode of a port to "general." To configure the default value, use the no form of
this command.
Syntax
switchport general pvid vlan-id
no switchport general pvid
• vlan-id — PVID. The VLAN ID may belong to a non-existent VLAN.
2CSPC4.XModular-SWUM200.book Page 742 Thursday, March 10, 2011 11:18 AM