Dell POWEREDGE M1000E - Manual (Page 1200)

1200 OSPFv3 Commands
------------ ------------- ---------- -----------------
0.0.0.10 Normal 1 Enable
show ipv6 ospf virtual-links
Use the show ipv6 ospf virtual-links command in Privileged EXEC mode to
display the OSPF Virtual Interface information for a specific area and
neighbor or for all areas in the system.
Syntax
show ipv6 ospf virtual-link [ area-id neighbor-id | brief]
• area-id — Identifies the OSPF area whose virtual interface information is
being displayed.
• neighbor-id — Router ID of neighbor.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for
area 1 and its neighbor.
console#show ipv6 ospf virtual-link 1 1.1.1.1
Area ID........................................ 1
Neighbor Router ID............................. 1.1.1.1
Hello Interval................................. 10
Dead Interval.................................. 40
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... point-to-point
2CSPC4.XModular-SWUM200.book Page 1200 Thursday, March 10, 2011 11:18 AM