Dell POWEREDGE M1000E - Manual (Page 1207)

Router Discovery Protocol Commands 1207
console(config)#interface vlan 15
console(config-if-vlan15)#ip irdp holdtime 2000
ip irdp maxadvertinterval
Use the ip irdp maxadvertinterval command in Interface Configuration
mode to configure the maximum time, in seconds, allowed between sending
router advertisements from the interface. Use the no form of the command to
set the time to the default value.
Syntax
ip irdp maxadvertinterval integer
no ip irdp maxadvertinterval
• integer — Maximum time in seconds allowed between sending router
advertisements from the interface. (Range: 4 or the minimum
advertisement interval, whichever is greater, and 1800 seconds)
Default Configuration
600 seconds is the default value.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
The default values of the minimum advertisement interval and the holdtime
depend on the value of the maximum advertisement interval. Setting the
maximum advertisement interval changes the minimum advertisement
interval and holdtime if those values are at their defaults; so, the maximum
advertisement interval should always be set first. If the minimum
advertisement interval has been configured to a non-default value, the
maximum advertisement interval cannot be configured to a lower value than
the minimum advertisement interval. If the holdtime has been configured to
a non-default value, the maximum advertisement interval cannot be
configured to a value larger than the holdtime.
2CSPC4.XModular-SWUM200.book Page 1207 Thursday, March 10, 2011 11:18 AM