Dell POWEREDGE M1000E - Manual (Page 1219)

Routing Information Protocol Commands 1219
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-vlan2)#ip rip
console(config-if-vlan2)#no ip rip
ip rip authentication
Use the ip rip authentication command in Interface Configuration Mode to
set the RIP Version 2 Authentication Type and Key for the specified VLAN.
Use the no form of the command to return the authentication to the default
value.
Syntax
ip rip authentication {none | {simple key } | {encrypt key key-id }}
no ip rip authentication
• none—Do not use RIP authentication on the VLAN.
• simple—Use simple authentication on the VLAN.
•
key — Authentication key for the VLAN. (Range: 16 bytes or less)
• encrypt — Use MD5 encryption for the RIP interface.
•
key-id — Authentication key identifier for authentication type encrypt.
(Range: 0-255)
Default Configuration
This command has no default configuration.
2CSPC4.XModular-SWUM200.book Page 1219 Thursday, March 10, 2011 11:18 AM