Dell POWEREDGE M1000E - Manual (Page 990)

990 IPv6 Routing Commands
DHCPv6 Release Packets Transmitted............. 0
Total DHCPv6 Packets Transmitted............... 0
show ipv6 mld groups
The show ipv6 mld groups command is used to display information about
multicast groups that MLD reported. The information is displayed only when
MLD is enabled on at least one interface. If MLD was not enabled on any
interfaces, there is no group information to be displayed.
Syntax
show ipv6 mld groups { group-address | vlan vlan-id }
• group-address — The group address to display.
• vlan-id — A valid VLAN id.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
The following fields are displayed as a table when vlan vlan-id is specified:
Field Description
Number of (*, G)
entries
Displays the number of groups present in the MLD Table.
Number of (S, G)
entries
Displays the number of include and exclude mode sources
present in the MLD Table.
Group Address The address of the multicast group.
Interface Interface through which the multicast group is reachable.
Uptime Time elapsed in seconds since the multicast group has been
known.
2CSPC4.XModular-SWUM200.book Page 990 Thursday, March 10, 2011 11:18 AM