Dell POWEREDGE M1000E - Manual (Page 1490)

1486 SNMP Commands
snmp-server contact
Use the snmp-server contact command in Global Configuration mode to set
up a system contact (sysContact) string. To remove the system contact
information, use the no form of the command.
Syntax
snmp-server contact text
no snmp-server contact
• text — Character string, 0 to 160 characters, describing the system contact
information.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays setting up the system contact point as
"Dell_Technical_Support".
console(config)# snmp-server contact
Dell_Technical_Support
snmp-server enable traps
Use the snmp-server enable traps command in Global Configuration mode to
enable sending SNMP traps globally or to enable sending individual SNMP
traps. Use the no form of this command to disable sending SNMP traps
individually or globally.
2CSPC4.XModular-SWUM200.book Page 1486 Thursday, March 10, 2011 11:18 AM