Dell POWEREDGE M1000E - Manual (Page 1029)

Multicast Commands 1029
Parameter Description
Default Configuration
None —no static multicast groups are configured for an RP.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip pim rp-address 192.168.21.1
239.1.0.0 255.255.0.0 override
ip pim rp-candidate
Use the ip pim rp-candidate command in Global Configuration mode to
configure the router to advertise itself to the bootstrap router (BSR) router as
a PIM candidate rendezvous point (RP) for a specific multicast group range.
Use the no form of this command to return to the default configuration. This
command replaces the ip pimsm rp-candidate command.
Syntax
ip pim rp-candidate vlan { vlanid group-address group-mask}
no ip pim rp-candidate vlan vlanid group-address group-mask}
Parameter Description
rp-address The valid IPv4 address for the rendezvous point.
group-address A valid multicast group address to be sourced from the
rendezvous point.
group-mask A mask indicating the range of multicast groups sourced from
the RP
override A flag indicating that the static entry should override
dynamically learned entries for the configured multicast group.
2CSPC4.XModular-SWUM200.book Page 1029 Thursday, March 10, 2011 11:18 AM