Dell POWEREDGE M1000E - Manual (Page 1384)

1380 Management ACL Commands
deny (management)
Use the deny command in Management Access-List Configuration mode to
set conditions for the management access list.
Syntax
deny [gigabitethernet unit/slot/port | vlan vlan-id | port-channel port-
channel-number | tengigabitethernet unit/slot/port ] [service service ] [priority
priority ]
deny ip-source ip-address [mask mask | prefix-length ] [gigabitethernet
unit/slot/port | vlan vlan-id | port-channel port-channel-number |
tengigabitethernet unit/slot/port ] [service service ] [priority priority ]
• gigabitethernet unit/slot/port — A valid 1-gigabit Ethernet-routed port
number.
• vlan vlan-id — A valid VLAN number.
• port-channel port-channel-number — A valid routed port-channel
number.
• tengigabitethernet unit/slot/port — A valid 10-gigabit Ethernet-routed
port number.
• ip-address — Source IP address.
• mask mask — Specifies the network mask of the source IP address.
• mask prefix-length — Specifies the number of bits that comprise the
source IP address prefix. The prefix length must be preceded by a forward
slash (/). (Range: 0–32)
• service service — Indicates service type. Can be one of the following:
telnet, ssh, http, https, tftp, snmp, sntp, or any. The any keyword indicates
that the service match for the ACL is effectively "don’t care".
• priority priority — Priority for the rule. (Range: 1–64)
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
2CSPC4.XModular-SWUM200.book Page 1380 Thursday, March 10, 2011 11:18 AM