Ip address none, Syntax, Default configuration – Dell POWEREDGE M1000E User Manual
Page 1547: Command mode, User guidelines, Example, Ip address {dhcp/bootp, Ip address, Dhcp/bootp
Advertising
System Management Commands
1543
ip address none
Use the ip address none command to disable DHCP/BOOTP on the OOB
port.
Syntax
ip address none
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (out-of-band)
User Guidelines
No specific guidelines.
Example
console(config)#interface out-of-band
console(config-if)#ip address none
ip address {dhcp/bootp}
Use the ip address command to enable DHCP/BOOTP on the OOB port.
Syntax
ip address {dhcp/bootp}
Command Mode
Interface Configuration (out-of-band)
Default Configuration
This command has no default configuration.
2CSPC4.XModular-SWUM200.book Page 1543 Thursday, March 10, 2011 11:18 AM
Advertising