Dell POWEREDGE M1000E - Manual (Page 792)

792 802.1x Commands
no dot1x guest-vlan
• vlan-id — The ID of a valid VLAN to use as the guest VLAN (Range: 0-
4093).
Default Configuration
The guest VLAN is disabled on the interface by default.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Configure the guest VLAN before using this command.
Example
The following example sets the guest VLAN on port 1/0/2 to VLAN 10.
console(config-if-1/0/2)#dot1x guest-vlan 10
dot1x unauth-vlan
Use the dot1x unauth-vlan command in Interface Configuration mode to
specify the unauthenticated VLAN on a port. The unauthenticated VLAN is
the VLAN to which supplicants that fail 802.1X authentication are assigned.
Syntax
dot1x unauth-vlan vlan-id
no dot1x unauth-vlan
• vlan-id — The ID of a valid VLAN to use for unauthenticated clients
(Range: 0-4093).
Default Configuration
The unauthenticated VLAN is disabled on the interface by default.
Command Mode
Interface Configuration (Ethernet) mode
2CSPC4.XModular-SWUM200.book Page 792 Thursday, March 10, 2011 11:18 AM