Dell POWEREDGE M1000E - Manual (Page 268)

268 Address Table Commands
Default Configuration
No Multicast addresses are defined.
Command Mode
Global Configuration mode
User Guidelines
If the command is executed without add or remove, the command registers
only the group in the bridge database.
Static Multicast addresses can be defined only on static VLANs.
Examples
The following example registers the MAC address.
console(config)#mac address-table vlan 8 multicast
static 0100.5e02.0203
The following example registers the MAC address and adds ports statically.
console(config)#interface vlan 8
console(config)# mac address-table vlan 8 multicast
static 0100.5e02.0203 add interface gigabitethernet
1/0/1-9, 1/0/2
mac address-table static
Use the mac address-table static command in Global Configuration mode to
add a static MAC-layer station source address to the bridge table. To delete
the MAC address, use the no form of the mac address-table static command.
ip-multicast-address IP multicast address.
interface
interface-
list
Specify a comma separated list of interfaces, a range of
interfaces, or a combination of both. Interfaces can be port-
channel numbers or physical ports in unit/slot/port format.
Parameter Description
2CSPC4.XModular-SWUM200.book Page 268 Thursday, March 10, 2011 11:18 AM